HappyJapan HCR3-1502, Maintenance Manual

Page: 212 / 216

212
No. message Error measure page
068 Position set Failure to read embroidery frame (1) Check if position sensor is dirty. E2-7
sensor signal. (Return) Turn off power source, then turn on again.
069 Position Entry Failure to read embroidery frame (2) Setup mistake of the machine parameter E5-5,-6
sensor signal. (Entry) (3) Replace position sensor circuit board. E2-7
070 Safety sensor Safety sensor has been tripped. (1)Clear area around safety sensor.
(2)Check material dose not shut out safety
sensor beam.
(3) Adjust safety sensor position. E6-3
090 Miss reception Error has occurred during data transfer (1)Let the machine read pattern data from first. ( 5-5 )
(via cable) between machine and PC.
091 No send Data is not put in for over 10 seconds. Let the machine read data from first. ( 5-5 )
103 Data format Machine unable to determine format of (1)Check format of pattern data. (5-6 )
pattern data. (2)By setting reading of pattern data, ( 10-3 )
104 Miss function Timing to read pattern data doesn't Read pattern data again from the first. ( 5-5 )
conform.
105 Dual function One stitch data has more than 2 (1)Read pattern data again from the first. ( 5-5 )
functions. (2)
Check and modify the design data if there is wrong.
106 No function Interval between start read time and Read pattern data again from the first ( 5-5 )
time of reception of actual pattern data
108 Improper read While reading pattern data, there Read pattern data again from the first. ( 5-5 )
accrued error in internal processing.
110 Memory full While reading pattern data, memory (1)Delete unnecessary patterns and read from ( 5-B )
exceeded its capacity. the outset. (23-1)
111 Change over While reading pattern data, the (1)
Modify pattern data and reduce frequency of color
frequency of color change (color No.)
change of one pattern to less than 250 times.
exceeded 250 times. (2)
Divide pattern data and reduce frequency of color
change of one pattern to less than 250 times.
112 Data error Pattern data of pattern to be (1)Read pattern data again from the first. ( 5-B )
embroidered is damaged. (2)Read pattern data again if you have
a backup data.
114 Id over The number of pattern in memory has Delete unnecessary patterns and read. ( 5-B )
reached maximum of 250.
116 Not found Id Specified pattern does not exist. (1)Check setting.
(2)Re-initialize machine system. E4-3
118 Trace data over The stitch number counts over 1024 Set Embroidery area of pattern data within
stitches during preparing Trace data. 2m(X) x 2m(Y).
( ) ----- Reference instruction book