GSM-20H10 User Manual
355
z
Bit B3, Low Limit 3 Fail (LL3) — Set bit indicates that the
Low Limit 3 test has failed.
z
Bit B4, High Limit 3 Fail (HL3) — Set bit indicates that the
High Limit 3 test has failed.
z
Bit B5, Limits Pass (LP) — Set bit indicates that all limit
tests passed.
z
Bit B6, Reading Available (RAV) — Set bit indicates that a
reading was taken and processed.
z
Bit B7, Reading Overflow (ROF) — Set bit indicates that the
volts or amps reading exceeds the selected measurement
range of the SourceMeter.
z
Bit B8, Buffer Available (BAV) — Set bit indicates that there
are at least two readings in the buffer.
z
Bit B9, Buffer Full (BFL) — Set bit indicates that the trace
buffer is full.
z
Bit B10 — Limit 4 - Contact Check.
z
Bit B11, Output Enable Asserted (Int) — Set bit indicates
that the output enable line is at digital low (asserted). The
source output can be turned on.
z
Bit B12, Over Temperature (OT) — Set bit indicates that an
over temperature condition exists. The source output
cannot be turned on.
z
Bit B13, Over Voltage Protection (OVP) — Set bit indicates
that the source is being limited at the programmed limit
level.
z
Bit B14, Compliance (Comp) — Set bit indicates that the
source is in compliance.
z
Bit B15 — Not used.
˙
Questionable Event Register
The used bits of the Questionable Event Register are described
as follows:
z
Bits B0 through B7 — Not used.
