BASIC OPERATION
122
Log
The output of the waveform depends on the following
parameters: Start value, Stop value, Points (log) number,
Delay time (Determined by Source delay, trigger delay and
Speed which can be set separately). As shown below:
When starting sequence, the output will go from the bias
level to the Start piont, and run to the Stop point in equal
logarithmic steps. When the trigger delay time is set to 0,
the time of each step is determined by the source delay time
and the time it takes to perform measurement (NPLC
setting).
NOTE: The value of logarithmic sequence mode
cannot be set as 0.
Custom Custom sequence type. It is necessary to set the number of
points and the source value of each sequence point.
When starting sequence, the output will go from the bias
level to the Start piont, and run to the Stop point in turn.
When the trigger delay time is set to 0, the time of each step
is determined by the source delay time and the time it takes
to perform measurement (NPLC setting). The delay is the
same for all the sequence points.
