GSM-20H10 User Manual
255
Function
This Command is used to manually set a delay
(settling time) for the source. After the programmed
source is turned on, this delay occurs to allow the
source level to settle before a measurement is taken.
NOTE : This delay is the same for both the I-
Source and V-Source.
Do not confuse this source delay with the trigger
delay. The source delay is part of the device action
(SDM cycle) while the trigger delay occurs before the
device action.
Auto delay can instead be used to automatically set
the source delay.
<n> = 0 to 999.9999 Specify delay in seconds
MINimum 0 seconds
MAXimum 999.9999 seconds
DEFault 0.001seconds
Example
:SOURce:DELay 0
Command
:SOURce[1]:DELay?
Function
:DELay? Query delay.
:DELay? DEFault Query *RST default delay.
:DELay? MINimum Query lowest allowable delay.
:DELay? MAXimum Query highest allowable
delay.
Example
:SOURce:DELay?
Command
:SOURce[1]:DELay:AUTO <b>
Function
This Command is used to enable or disable auto
delay. When enabled, the instrument will
automatically select a delay period that is appropriate
