BASIC OPERATION
128
e
Press Enter, enter a number between 1-100, press
Enter, the following dialog box appears, move
the cursor to OK button and press Enter, which
means to recall the settings in the corresponding
memory location indicated by the number in the
Memory restore box to present Source interface.
Points
SRC-MEM memory sequence points, value: 100-Start
location.
Operation: Use the arrow keys to place the cursor on
Points (the numbers on the edit box turn into red
letters on a gray background), enter the editing state
after Enter, enter the required value according to the
position with the number keys, and then Enter to
confirm.
Custom waveform
Custom sequence type. Used to set the number of
measurement points in the sequence and the source
level of each point.
Number of
points
Used to set the number of measurement points in the
sequence.
Setting: Press the F3 (Custom) key, the cursor jumps
to the Number of points option box, press Enter key
enter the editing state, input the required number (0
to 2499) and press Enter to confirm.
V/I Edit
There are two ways: Block Edit (setting the points in
the block to the same source level) and Single Edit.
Press the F2 (Block) key, the cursor jumps to the Start
point, set the start position, set the end position in the
Stop point option and set the source level in the Value
box, and the source level of the points set in the Block
are the same.
Press the F3 (Single) key to set the parameters of a
single point.
