190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
559
Appendix A
GiA 63W inteGrAted Avionics unit sYsteM MessAGes
System Message
Comments
GIA1 CoNFIG
– GIA1 config
error. Config service req’d.
The GIA1 and/or GIA2 configuration settings do not match backup configuration memory. The
system should be serviced.
GIA2 CoNFIG
– GIA2 config
error. Config service req’d.
GIA1 CoNFIG
– GIA1 audio
config error. Config service
req’d.
The GIA1 and/or GIA2 have an error in the audio configuration. The system should be serviced.
GIA2 CoNFIG
– GIA2 audio
config error. Config service
req’d.
GIA1 CooLING
– GIA1
temperature too low.
The GIA1 and/or GIA2 temperature is too low to operate correctly. Allow units to warm up to
operating temperature.
GIA2 CooLING
– GIA2
temperature too low.
GIA1 CooLING
– GIA1 over
temperature.
The GIA1 and/or GIA2 temperature is too high. If problem persists, the system should be serviced.
GIA2 CooLING
– GIA2 over
temperature.
GIA1 SeRVICe
– GIA1 needs
service. Return the unit for
repair.
The GIA1 and/or GIA2 self-test has detected a problem in the unit. The system should be serviced.
GIA2 SeRVICe
– GIA2 needs
service. Return the unit for repair.
HW MISMAtCH
– GIA1
hardware mismatch, GIA1
communication halted.
A GIA mismatch has been detected, where only one is WAAS capable.
HW MISMAtCH
– GIA
hardware mismatch, GIA2
communication halted.
GIA1 MANIFeSt
– GIA1
software mismatch,
communication halted.
The GIA1 and/or GIA 2 has incorrect software installed. The system should be serviced.
GIA2 MANIFeSt
– GIA2
software mismatch,
communication halted.
GFC MANIFeSt
– GFC software
mismatch, communication halted. Incorrect servo software is installed, or gain settings are incorrect.
CoM1 teMP
– COM1 over temp.
Reducing transmitter power.
The system has detected an over temperature condition in COM1 and/or COM2. The transmitter
operates at reduced power. If the problem persists, the system should be serviced.
CoM2 teMP
– COM2 over temp.
Reducing transmitter power.
This manual downloaded from http://www.manualowl.com