190-01263-01 Rev. A
Garmin G2000 Pilot’s Guide for the Cessna T240
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
581
Appendix B
13)
Touch the
PFD2
Button. Verify the PFD2 Database screen indicates the standby navigation database is synchronizing.
When synchronization has finished, ‘Complete’ is displayed. Check the standby navigation database information
to verify database have been updated.
14)
Touch the
Back
Button.
15)
Touch the
MFD1
Button. Check the standby navigation database information to verify the database has been
updated.
16)
Touch the
Back
Button.
17)
Touch the
GtC1
Button. Check the standby navigation database information to verify databases have been
updated.
18)
Touch the
Back
Button.
Note:
During the synchronization process, version differences between standby navigation databases will exist.
This will result in the system displaying a ‘DB Mismatch’ alert for the standby navigation databases. This alert will
remain until the next power cycle.
19)
Remove power from the system.
20)
Remove the SD card from the top card slot of the MFD.
21)
Apply power to the system.
22)
Acknowledge the Power-Up display agreement by pressing the right most softkey as indicated on the display.
23)
From the
Home
Screen on the Touchscreen Controller, touch
Setup
>
Avionics Status
.
24
Touch the
Database
Tab.
25)
Touch the
PFD1
Button. Check the standby navigation database information to verify database have been
updated.
26)
Touch the
Back
Button.
27)
Touch the
MFD1
Button. Check the standby navigation database information to verify the database has been
updated.
28)
Touch the
Back
Button.
29)
Touch the
GtC1
Button. Check the standby navigation database information to verify databases have been
updated.
30)
Touch the
Back
Button.
AutoMAtic dAtABAse sYncHronizAtion feAture
When updating the active navigation database, the automatic database synchronization feature automatically
transfers the navigation database from a single SD Card to the internal memories of the PFD, MFD, and
Touchscreen Controller. When updating all other databases (including the standby navigation database, but
not including charts or terrain databases) the data is transferred from a single SD card to the remaining SD
cards on the PFD and MFD, as well as the internal memory of the Touchscreen Controller. After power-up, the
This manual downloaded from http://www.manualowl.com
