Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A
434
Hazard avoidance
SY
ST
eM
o
ver
vie
W
FL
iGHT
in
ST
rUM
en
TS
ei
S
a
Udio
&
cn
S
FL
iGHT
M
ana
G
eM
en
T
Hazard
av
oid
ance
a
Fc
S
addi
Tiona
L
Fea
TU
re
S
a
PP
endice
S
inde
X
4)
Touch the
Map Settings
Button.
5)
Touch the
Labels
Button to enable/disable the display of labels on traffic (such as relative altitude).
6)
To change the map range above which the system removes traffic symbols from the map, touch the
Symbols
Range
Button,
then scroll to and touch to select a map range above which the system will remove the traffic
symbols.
7)
To change the map range at which the system removes traffic labels from the map, touch the
Labels
Range
button, then scroll to and touch to select a map range above which the system removes traffic labels from the
map.
8)
When finished, touch the
Back
or
Home
.
SySTEM STATUS
The traffic mode appears in the upper right corner of the Traffic Map Pane.
Mode
Traffic Mode Annunciation
(Traffic Map Pane)
Traffic Display Status Icon
(Other Maps)
TAS System Test
Initiated
TEST
(TEST MODE shown in top center of Traffic Map display)
TAS Operating
OPERATING
TAS Standby
STANDBy
(also shown in center of Traffic Map display)
TAS Failed*
FAIL
* See Table 6-26 for additional failure annunciations
Table 6-25 Traffic Modes
If the traffic unit fails, the system shows an annunciation as to the cause of the failure in the center of the
Traffic Map Pane. During a failure condition, the Operating Mode is not available.
Traffic Map Page Center
Annunciation
Description
NO DATA
System is not receiving any data from the TAS unit.
DATA FAILED
System is receiving data from the TAS unit, but the
unit is reporting a failure.
FAILED
The TAS unit is sending invalid data to the system.
Table 6-26 Traffic Failure Annunciations
This manual downloaded from http://www.manualowl.com
