Garmin G2000 Pilot’s Guide for the Cessna T240
190-01263-01 Rev. A
302
Flight ManageMent
SY
Ste
M
O
Ve
RV
ie
W
Flight
in
St
RUM
ent
S
ei
S
aUD
iO P
anel
& C
n
S
Flight
M
ana
ge
M
ent
ha
Za
RD
aV
O
iD
an
Ce
a
FCS
a
DD
iti
O
nal
Fea
tUR
eS
a
PP
en
D
iC
eS
in
D
eX
COURSE TO ALTITUDE
In this missed approach procedure, the altitude immediately following the MAP (in this case ‘1426ft’) is not
part of the published procedure. It is simply a Course to Altitude (CA) leg which guides the aircraft along
the runway centerline until the required altitude required to safely make the first turn toward the MAHP
is exceeded. In this case, if the aircraft altitude is below the specified altitude (1,426 feet) after crossing
the MAP, a direct-to is established to provide a course on runway heading until an altitude of 1,426 feet
reached. After reaching 1,426 feet, a direct-to is established to the published MAHP (in this case LYMES).
If the aircraft altitude is above the specified altitude after crossing the MAP, a direct-to is established to the
published fix (LYMES) to begin the missed approach procedure. The altitude constraint value defaults to
400 feet AGL when there is no Course to Altitude defined in the published procedure.
In some missed approach procedures this Course to Altitude leg may be part of the published procedure.
For example, the procedure dictates a climb to 5,500 feet, then turn left and proceed to the Missed Approach
Hold Point (MAHP). In this case, The altitude would be appear in the list of waypoints as ‘5500ft’. Again, if
the aircraft altitude is lower than the prescribed altitude, a direct-to is established on a Course to Altitude leg
when the missed approach procedure is activated.
Figure 5-153 Course to Altitude
Course to Altitude Leg
This manual downloaded from http://www.manualowl.com
