FOR-A HVS-12ROUA, Installation And Operation Manual

Page: 46 / 250

32
IMPORTANT
Holding down the DEF button when the WIPE POS or DVE ROT button is lit returns
all of the WIPE MODIFY data or DVE MODIFY data to their factory default settings.
4-5-1. Returning Menus to Default

INIT parameter
All the settings in the menus below can be returned to their default values with one operation.
Menu returned to default INIT item selection
* MU SETUP (MU SETUP – SYSTEM menu) CUR, SYS, ALL
* OU SETUP (OU SETUP – MODE menu) OFF, ON
* For details about MU SETUP and OU SETUP menu initialization, refer to 15-6. "Reboot and Initialization"

Returning KEY menus to default
The KEY menus can be returned to the default settings by holding down the menu button of
the appropriate key in the M/E1 or M/E2 group in the menu section. When the button is held
down, a long beep is made, and then the selected parameters are returned to the defaults.
However, the crosspoint selection for the bus is not returned to the default setting. In
HVS-12ROUA, each keyer top menu has an INIT item that can return the keyer menu to the
default settings.
Section Menu button Parameters returned to default
M/E1,
M/E2
KEY1 All KEY1 parameters
* MATT MASK (KEY1) KEY1 MATT and MASK-related parameters
* EDGE SHADOW (KEY1) KEY1 EDGE and SHADOW-related parameters
* CK (KEY1) KEY1 CHROMAKEY-related parameters
KEY2 All KEY2 parameters
* MATT MASK (KEY2) KEY2 MATT and MASK-related parameters
* EDGE SHADOW (KEY2)
KEY2 EDGE and SHADOW-related parameters
* CK (KEY2)
KEY2 CHROMAKEY -related parameters
KEY3 All KEY3 parameters
* MATT MASK (KEY3) KEY3 MATT and MASK-related parameters
* Buttons on HVS-16/24OUA units are available.
4-5-2. Returning to User Default
You can also use parameters preset by the user as the default settings. The user defaults are
then used as the initial values of the normal parameters. Once the user default values are set,
the user defaults can be enabled with the normal operation for returning to the parameter
initial values. See section 15-4. "User Default” for details about making the user default
settings.
WIPE MODIFY(1/3)
MULTI
X
1
Y
0
X
0
Y
1
SOFT
0.0
ASPECT
0.0
POSITION
TYPE
OFF
LEVEL
0
EFFECT
ANGLE
0.0
INVERT
OFF
Changes can be made for the X, Y, and Z buttons
that are lit only.
Z
MENU
L
DEF
MENU
R
X
WIPE
POS
Y
JOYSTICK
DVE
ROT
Cursor bar