FOR-A HVS-12ROUA, Installation And Operation Manual

Page: 40 / 250

26
4-3-5. Joystick Input
You can also use the joystick for making settings in menus. The general procedures for
making and changing operational menu settings using a joystick are as follows.
 The X, Y, and Z axes of the joystick are used to change three parameters at once.
X-axis
Move the joystick to the right or left.
Y-axis Move the joystick up or down.
Z-axis Turn the joystick clockwise or counterclockwise.
 When the buttons next to the joystick are pressed to turn them on, the three parameters
can be adjusted at the same time.
MENU TOP-L button Three blocks on the left side of the menu screen
(in the order of X, Y, and Z from the left)
MENU TOP-R button Three blocks on the right side of the menu screen
(in the order of X, Y, and Z from the left)
(The cursor bar indicates which part of the menu (upper or bottom) is being controlled.)

WIPE POS and DVE ROT buttons
The WIPE POS and DVE ROT buttons are shortcuts to the respective menu. Clicking the
button lights it up and enables you to change the setting without opening the menu.
Double-clicking the button takes you directly to the parameter of the selected pattern.
WIPE POS button When WIPE is selected, this moves to POSITION (X, Y) in the WIPE
MODIFY(1/3) menu.
When DVE is selected, this moves to POSITION (X, Y, Z) in the DVE
MODIFY(1/8) menu.
DVE ROT button When DVE is selected, this moves to the LOCAL ROTATION (X, Y, Z) in the
DVE MODIFY(2/8) menu. In the case of the DVE ROT button, the bus
where this modify is applied is selected by the DVE PGM, DVE PST, DVE
KEY1, DVE KEY2, or DVE KEY3 button in the menu section.
IMPORTANT
Note that you cannot use the joystick to input settings to the MU SETUP and OU
SETUP menus.
WIPE MODIFY(1/3)
MULTI
X
1
Y
0
X
0
Y
1
SOFT
0.0
ASPECT
0.0
POSITION
TYPE
OFF
LEVEL
0
EFFECT
ANGLE
0.0
INVERT
OFF
Changes can be made for the X, Y,
and Z buttons that are lit.
Z
MENU
L
DEF
MENU
R
X
WIPE
POS
Y
JOYSTICK
DVE
ROT
Cursor bars