FOR-A HVS-12ROUA, Installation And Operation Manual

Page: 95 / 250

81
6-6. Selecting the Pattern
The pattern transition can be executed simultaneously for multiple buses. In this case a pattern
must be set for each bus before execution of the transition. This section describes the procedure
for selecting the pattern.
6-6-1. Selecting the Pattern

Bus that selects the pattern
Press the transition button from BKGD, KEY1, KEY2, and KEY3 so that the bus indicator
next to the transition rate lights up. Next, press the WIPE button to light it, and set the
transition type to WIPE so that the selected transition lights up at the right of the pattern block.
(When a DVE pattern is selected for the pattern, the DVE WIPE lamp next to WIPE lights up.)

Selecting the pattern
Five pattern buttons are provided in the pattern block of the transition section. Press one of
these pattern buttons to select a pattern. Also, double-clicking the pattern button displays the
WIPE PATTERN menu on the screen. (The WIPE PATTERN menu can also be displayed by
pressing the WIPE PATT button in the M/E1 or M/E2 group of the menu section.)
Currently, these five patterns are displayed in the transition section. The currently selected
patterns are lit in the pattern block. In the example below, KEY2 is the No. 120 pattern and is
set to DVE transition. When the TIE is OFF, the pattern selection can be made only when
holding down a keyer button (KEY1, KEY2 or KEY3).
Displaying the pattern you want to use in the pattern block
The patterns displayed in the menu screen can be easily changed. Turning controls F1 to F5
enables the patterns for the respective blocks to be changed. When the patterns are changed
here, the patterns are changed simultaneously in the transition section. In this way, 100
WIPE patterns, 120 DVE patterns, and 50 user patterns can be selected.
Pattern setup
In the WIPE PATTERN menu, 5 groups for a total of 25 patterns (1 group = 5 patterns) can be
stored. In the default settings, Nos. 0 to 24 are stored. Turning F6 in the WIPE PATTERN list
menu enables the group to be switched. When the group is switched, the pattern block
display is also changed. For details about the available patterns, refer to the pattern list in the
appendix at the end of this manual.
AUTO
AUTO
KEY2 KEY1
AUTO
AUTO
REV
PREV
MIX WIPE
CUT NAM FAM
FADER
LIMIT
TRANS
NOR
REV
DVE DVE DVE DVE
TRANSITION RATE
WIPE DIRECTION
KEY3
KEY3
CUT
MIX
KEY1 KEY2
BLACK
TRANS
BKGD
KEY1
KEY2
KEY3
BKGD
DVE WIPE DVE WIPE
WIPE
Transition section (HVS-16/24OUA)
Menu screen
Pattern block
(Pattern selection)
The same pattern is selected in the
menu screen and pattern block.
If the pattern is changed in the menu,
the pattern block also changes to
reflect this.
Currently-selected pattern
WIPE PATTERN SELECT
120 121
WIPE
002 003 401
LIST
No.
1
BKGD
KEY2 KEY1
Selected
transition lights
up.