FOR-A HVS-12ROUA, Installation And Operation Manual

Page: 160 / 250

146
14-3. Color Correction Flow
Color correction can be set using the Color Correction menu. Press the FUNC button in the
menu section to open the COLOR CORRECTION menu from the FUNCTION top menu.
Select a color correction channel
(MODULE, CHAN)
See section 14-4.
↓
Select a signal to be assigned to the channel
(TYPE, SELECT)
See section 14-4.
↓
Enable the color correction channel
(Set ENABLE to ON)
See sections 14-4 and 14-8-2.
Proc Amp Control
(See section 14-5.)
Color Correction Adjustment
(See section 14-6.)
Clip Adjustment
(See section 14-7.)
Luminance level
(Y LEVEL)
Chroma level (C LEVEL)
Chroma phase (C PHASE)
Video level (V LEVEL)
Black level (BLACK)
Mode Selection (CC MODE) Mode Selection (CLIP MODE)
BALANCE DIFFERENTIAL SEPIA YPbPr RGB
RGB WHITE LEVEL
RGB BLACK LEVEL
RGB GAMMA LEVEL
RGB GAMMA CURVE
SAT
HUE
Y WHITE LEVEL
Y BLACK LEVEL
C WHITE LEVEL
WHITE LEVEL
BLACK LEVEL
IMPORTANT
To fully or partly initialize color correction menu settings, select under the INIT
parameter from ALL, PROC , CC or CLIP and then press and hold the relevant
function button down for a while.
14-4. Assigning A Color Correction Channel
To assign a signal to a color correction channel, proceed as follows:
 Press the FUNC button in the menu section to open the FUNCTION top menu. Turn F1 in
the menu to select 5 COLOR CORR. Then press F1 or DOWN button to open the COLOR
CORRECTION menu.

Turn F2 to select a color correction channel under the CHAN item. The selected channel is
indicated in upper right of display.

To select a signal to be assigned to the selected color correction channel, at first specify the
control type (BUS, INPUT or BUTTON) under the TYPE item and then select a signal under
the SELECT item. (See the below tables.)
COLOR CORRECTION (1/4) CH1/PGM
MODULE
ME1 BG
Y LV
100%
CHAN
CH1
C LV
100%
CC CONTROL
TYPE
BUS
PROCESS CONTROL
C PHS
0
SELECT
PGM
V LV
0%
ENABLE
OFF
BLACK
0
INIT
OFF
LED
COLOR
OFF