FOR-A HVS-12ROUA, Installation And Operation Manual

Page: 94 / 250

80
6-5. Simultaneous (TIE) Transitions
IMPORTANT
The transitions are always performed simultaneously (TIE transitions) when selecting
the background and keyer(s) at the same time for transition in HVS-12ROUA. In
HVS-16/24OUA, Simultaneous (TIE) transitions can be performed only when the TIE
transition setup is made.
This section presents examples of transition operation using M/E2. Operation with
M/E1 is almost identical.
6-5-1. HVS-16/24OUA
By using TIE function, multiple layers (buses), such as background and keys, can perform a
transition simultaneously. This is performed in the following way.

Open the FADER submenu from the OU SETUP menu. Set the TIE option to ON. When
the TIE function is set to ON, the BKGD, KEY1, KEY2, and KEY3 buttons in the transition
section change to TIE mode.

Set the transition types for the BKGD, KEY1, KEY2, and KEY3 buses. Select the pattern
if using a WIPE/DVE transition.
NOTE
The WIPE pattern can be applied to two buses at the same time, but it must be the
same pattern. The DVE pattern can be applied to two or more buses, but it is limited to
the available number of DVE channels. For details, refer to section 6-9-8. "DVE
patterns and number of channels".

If necessary, set the transition rate, transition direction, and other parameters. For details,
see 6-9. "Other Transition Settings".

After the transition settings are complete, check the image after transition in the Preview
screen. For details about the Preview settings, refer to section 5-5-2. "Selecting Preview
Output" and section 6-3-3. "Background Preview."

Press the TIE mode buttons where you want the TIE transition to be performed to light
the button.

Use the fader lever or the AUTO button to perform the TIE transition. The selected buses
perform the transition at the same time.
AUTO
AUTO
KEY2 KEY1
AUTO
DVE DVE DVE
TRANSITION RATE
KEY3
KEY3
WIPE
CUT
MIX
KEY1 KEY2
BLACK
TRANS
BKGD
KEY1
KEY2
KEY3
DVE WIPE DVE WIPE
NAM
MIX
PREV
REV
NOR
REV
WIPE
FAM
WIPE DIRECTION
LIMIT
BKGD
CUT
DVE WIPE
DVE
TRANS
FADER
AUTO
TIE mode button
Fader lever or AUTO button is used to
execute the TIE transition.