195
Message List
Message
Status
Clearing Flash.
Clearing Flash data
Writing to Flash.
Writing data
Writing to CPU.
Writing to CPU
Check Checking
sum
Completed.
Upgrade finished successfully
Once the firmware upgrade is finished successfully, "Completed." is displayed on the
screen as shown below. This process takes from three to five minutes to complete.
If any error messages in the table below are displayed, check the following points and
repeat the procedure from step 3. Select only the failed card in the next upgrade process,
if an error appears on either one of two cards.
Is the upgrade file selected correctly?
Is the DVE card selected correctly?
Error Message
Status
Err. [5]
Error occurred (DVE timed out)
Err. [6]
Error occurred (DVE format data clearing error)
Err. [7]
Error occurred (DVE format data writing error)
Err. [8]
Error occurred (Transmission SUM error)
Err. [9]
Error occurred (Writing SUM error)
No DVE board.
No DVE card is installed.
MU-OU trans err.
MU-OU transmission error (MU Busy, SEQ ERR)
Reboot the MU.
Repeat this procedure from step1 to step 7 until all necessary upgrading of files is
completed.
After upgrading is finished, verify that the new version number of the DVE card appears
on the menu. (See section 16-8-1. "Checking the DVE Card Version.")
Reboot MU
DVE1: Completed
DVE2: Completed
Summary of Contents for HVS-12ROUA
Page 25: ...11 Circuit Max voltage 40V External Device HVS 3800HS S Max load current 100mA...
Page 240: ......
Page 248: ......
