FOR-A HVS-12ROUA, Installation And Operation Manual

Page: 76 / 250

62
5-6-7. Key Link
When the key link function is set to ON, the key source signal and key insert signal are linked
to form a pair. When the key source signal and key insert signal are selected, they are
automatically registered as a pair. Also, if a key insert signal only is selected, then a key
source signal is automatically selected to pair with it. To change the pair, use the key menu or
AUX/KEY bus to reselect the key source signal. The key link ON/OFF settings are made in
the MU SETUP – MODE menu.
NOTE
If a key link is set in one of the key menus of KEY1, KEY2, or KEY3, the same key pair
can also be used by other keys. The key pair setting can be used regardless of
whether the key link function is set to ON or OFF.

Setting key link function to ON
 Press the MU SETUP button in the SYSTEM group to display the MU SETUP top menu.

Turn F1 to select 4 MODE. Either press F1 or press the DOWN button to display the MU
SETUP – MODE menu. Change the KEYER MODE – LINK option to ON. Press ENTER
in the keypad to confirm.
5-6-8. Available Signals
The key signals are not limited only to those assigned to the bus buttons. All of the signals
below can be used by selecting them from the menu.
IMPORTANT
If using the key link function to select a signal in the AUX/KEY bus section, please note
that the selection cannot be made unless the key insert signal is assigned to a bus
button.
KEY Signal Description
M/E1
M/E2
KEY1
KEY2
KEY3
BLAK Internally generated Black signal
IN01-IN28 Primary input 01 to 28
STL1-STL6 Still 1 to Still 6
MATT1-MATT2 Color matt 1 and 2
KEY MATT Key matt (Refer to 5-6-9. "KEY MATT".)
GMATT Gradation matt (Refer to section 5-3. "Gradation Matt".)
WHITE Internally generated White signal
CB Internally generated color bar signal
M/E2
KEY1
KEY2
KEY3
M/E1PGM M/E1 PGM Signal
MU SETUP MODE
M/E1
REG
LINK
ON
M/E2
REG
KEYER MODE
GAIN
TYPE1
SET
INPUT
AUTO
TAKE
PAUSE
FADER
MIX
TRANS CTRL
M/E1
TYPE_P
M/E2
TYPE_P
EV-RCL MODE