Exinda EXNV-10063, Administration Manual

Page: 371 / 623

Exinda Network Orchestrator 4 Settings | 371
Which interfaces are DHCP enabled for each model?
Model Factory default DHCP enabled interface
2000, 2061, 4000 br1
5000, 6000, 6010 eth0
2060, 4010, 4060, 4061, 6060, 6062, 8060, 8062, 10060, 10062 eth1
To configure a static address
1. Enter an IPv4 or IPv6 address and netmask.
2.
You can optionally add a comment describing how the interface is to be used in the
Comment
field.
To configure the gateway settings
Enter the address of your network's default IPv4 and IPv6 gateways.
4.1.3 Routes configuration
Static routes may need to be defined when access to external networks cannot be reached via the default gateway. This
may be necessary so the appliance can connect to services such as DNS or NTP.
Routing table entries are shown for IPv4 and IPv6 networks. The destination, gateway, interface, source and state is
shown for each route. Routing table entries can have multiple sources:
static A manually configured route.
interface Derived from the addresses assigned to an interface.
SLAAC Assigned from SLAAC autoconfiguration.
DHCP Assigned from DHCP autoconfiguration.