Exinda EXNV-10063, Administration Manual

Page: 241 / 623

Exinda Network Orchestrator 3 Using | 241
To determine if a particular virtual circuit is consuming an appropriate amount of bandwidth
View the throughput charts as a line chart with the remaining traffic category toggled off so that each virtual circuit has a
common zero baseline. Compare the line for the virtual circuit relative to the bandwidth that was assigned to that virtual
circuit.
To configure a virtual circuit
Create a virtual circuit. See
Virtual Circuits
.
To show more or fewer virtual circuits in the top virtual circuits chart and the throughput chart
The number of virtual circuits shown are configurable. Note that this configuration applies to all charts on the appliance.
For more information, refer to Monitoring Configuration (page 446). .
Should subnet totals match virtual circuit totals when the virtual circuit and subnet are based on the same
network object?
In general, yes. However, there are some cases where the traffic direction is different for subnets versus virtual circuits
and so the totals will not match.
For more information, refer to Determining traffic direction and the implications of
directional flow on reports (page 238).