![background image](http://html1.mh-extra.com/html/esco/invt-gd350a-series/invt-gd350a-series_product-manual_2426081052.webp)
GD350A series high-performance multifunction VFD
-47-
"Default value" indicates the default value of this parameter.
5.4.6 Parameter setup edit interface
In the fourth-level menu in "parameter setup" menu, press
key,
key or
key to enter
parameter setup edit interface. After entering edit interface, set the parameter from low bit to high bit,
and the bit under setting will be highlighted. Press
key or
key to increase or decrease the
parameter value (this operation is valid until the parameter value exceeds the max. value or min.
value); press
or
to shift the edit bit. After parameters are set, press
key or
key
to save the set parameters and return to the previous parameter. In parameter setup edit interface,
press
to maintain the original parameter value and return to the previous menu.
01: GD350A
16:02:35
Forward Local
Ready
P00.00: Speed control mode
P00.01: Running command channel
P00.02: Communication command channel
P00.03: Max. output frequency
P00.04: Upper limit of running frequency
P00.05: Lower limit of running frequency
Max. output frequency Hz
050.0
0
Max. value: 630.00
Min. value: 50.00
Current value
:
50.00
Authority:
√
Default value: 50.00
Max. output frequency Hz
050.0
1
Max. value: 630.00
Min. value: 50.00
Current value
:
50.00
Authority:
√
Default value: 50.00
Add
Return
Select
Homepage
Return
Confirm
Homepage
Return
Confirm
Figure 5.16 Parameter setup edit interface
In parameter selection edit interface, the "authority" on the top right indicates whether this parameter
can be modified or not.
"
√
" indicates the set value of this parameter can be modified under current state.
"×" indicates the set value of this parameter cannot be modified under current state.
"Current value" indicates the value saved last time.
"Default value" indicates the default value of this parameter.
5.4.7 State monitoring interface
In the fourth-level menu of "state monitoring/fault record" menu, press
key,
key or
key to enter state monitoring interface. After entering state monitoring interface, the current parameter
value will be displayed in real time, this value is the actually detected value which cannot be modified.
In state monitoring interface, press
key or
key to return to the previous menu.