Epson AcuLaser C8500, Service Manual

Page: 217 / 570

EPSON AcuLaser C8500 Revision C
Disassembly/Assembly/Adjustment Disassembly/Assembly Procedures 3-65
3.2.11.5 2ND BTR CAM ASSY (PL8.1.1) Removal
1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)
2. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)
3. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSY. (See Section 3.2.5.5/Section 3.2.5.6/
Section 3.2.5.7.)
6. Remove the ROS ASSY. (See Section 3.2.9.3.)
7. Remove the XL RAIL ASSY. (See Section 3.2.9.5.)
8. Remove the FUSER ASSY. (See Section 3.2.12.1.)
9. Remove the BELT CLEANER ASSY. (See Section 3.2.11.4.)
10. Remove the 2ND BTR ASSY. (See Section 3.2.11.4.)
11. Remove the BTR CAM CLUTCH. (See Section 3.2.11.9.)
12. Remove the HVPS. (See Section 3.2.16.2.)
13. Remove the PROCESS DRIVE ASSY. (See Section 3.2.14.6.)
14. Pull out the MSI/REGI HIGH ASSY.
15. Remove the TRANSFER HIGH ASSY. (See Section 3.2.11.2.)
16. Remove the 2 screws (black, tapping, 10mm) securing the IBT FRONT
BRACKET ASSY, and remove the IBT FRONT BRACKET ASSY.
17. Disconnect the BTR WHEEL SENSOR connector (P/J100).
18. Remove the 3 screws (black, w/collar, 4mm) securing the 2ND BTR CAM
ASSY, and remove from the front hole of the BASE FRAME ASSY.
Figure 3-71. 2ND BTR CAM ASSY Removal