Enterasys SECURESTACK C3, Configuration Manual

Page: 377 / 872

set cos port-resource irl
SecureStack C3 Configuration Guide 11-27
Mode
Switch command, read ‐ write.
Usage
The default port group 0.0 cannot be deleted.
Example
This example deletes all IRL Port Groups except for the Default group 0.0:
C3(su)->clear cos port-config irl all
set cos port-resource irl
Use this command to set the inbound rate limit parameters for a specific IRL resource for a specific
port group.
Syntax
set cos port-resource irl group-type-index irl-index {[ unit { kbps }] [ rate rate ]
[ type { drop }]}[ syslog enable | disable ] [ trap enable | disable ]
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
group ‐ type ‐ index Specifies an inbound rate limiting port group/type index. Valid entries are
in the form of group#.port ‐ type .
Valid values for group# can range from 0 to 7. Valid values for port ‐ type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0 .
irl ‐ index Index number of the inbound rate limiter resource associated with this
entry. Valid values range from 0 to 99.
unit Unit of measure for the inbound rate limiter (only option is Kbps).
kbps Kilobits per second.
rate rate Data rate for this inbound rate limiter. This is the actual rate limit. Valid
values range from 512 to 1,000,000 Kbps for a Gigabit port.
type drop Action for the rate limiter. The only action option is drop the frame if all
limiters are exceeded.
syslog
enable|disable
Enable or disable reporting a syslog entry if limiters are exceeded.
trap enable|disable Enable or disable sending a trap if limiters are exceeded.