Enterasys SECURESTACK C3, Configuration Manual

Page: 202 / 872

set port broadcast
7-34 Port Configuration
ge.1.2 0 50
ge.1.3 0 40
ge.1.4 0 14881
set port broadcast
Use this command to set the broadcast suppression threshold, in packets per second, on one or
more ports. This sets a threshold on the broadcast traffic that is received and switched out to other
ports.
Syntax
set port broadcast port-string threshold-val
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Usage
Per port broadcast suppression is hardset to be globally enabled on the C3. If you would like to
disable broadcast suppression, you can get the same result by setting the threshold limit for each
port to the maximum number of packets which can be received per second as listed in the
parameters section, above. The default broadcast suppression threshold for all ports is set to
14881.
Example
This example configures ports 1 through 5 with a broadcast limit of 50 pps:
C3(su)->set port broadcast ge.1.1-5 50
clear port broadcast
Use this command to clear the broadcast threshold limit to the default value of 14881 for the
selected port.
Syntax
clear port broadcast port-string threshold
port ‐ string Select the ports for which to configure broadcast suppression thresholds.
For a detailed description of possible port ‐ string values, refer to “ Port
String Syntax Used in the CLI ” on page 7 ‐ 1.
threshold ‐ val Sets the packets per second threshold on broadcast traffic. Maximum
value is
• 148810 for Fast Ethernet ports
• 1488100 for 1 ‐ Gigabit ports.
• 14881000 for 10 ‐ Gigabit ports