Enterasys SECURESTACK C3, Configuration Manual, Page: 571 / 872

SecureStack C3 Configuration Guide 20-1
20
IPv4 Routing Protocol Configuration
This chapter describes the IPv4 Routing Protocol Configuration set of commands and how to use
them.
Activating Advanced Routing Features
In order to enable advanced routing protocols, such as OSPF, DVMRP, VRRP, and PIM ‐ SM, on a
SecureStack C3 device, you must purchase and activate a license key. If you have purchased an
advanced routing license, and have enabled routing on the device, you can activate your license as
described in the chapter entitled “Activating Licensed Features.”
If you are stacking your devices and require advanced routing features, all devices in the stack
must have a valid license.
If you wish to purchase an advanced routing license, contact Enterasys Networks Sales.
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to “ Enabling Router
Configuration Modes ” on page 18-2.
For information about... Refer to page...
Activating Advanced Routing Features 20-1
Configuring RIP 20-2
Configuring OSPF 20-11
Configuring DVMRP 20-33
Configuring IRDP 20-37
Configuring VRRP 20-42
Configuring PIM-SM 20-49
Note: The command prompts used in examples throughout this guide show a system where the
VLAN 1 interface has been configured for routing. The prompt changes depending on your current
configuration mode, your specific device, and the interface types and numbers configured for
routing on your system.