Enterasys SECURESTACK C3, Configuration Manual, Page: 147 / 872

show lldp
SecureStack C3 Configuration Guide 6-15
show lldp
Use this command to display LLDP configuration information.
Syntax
show lldp
Parameters
None.
Defaults
None.
Mode
Switch command, read ‐ only.
Example
This example shows how to display LLDP configuration information.
C3(ro)->show lldp
Message Tx Interval : 30
Message Tx Hold Multiplier : 4
Notification Tx Interval : 5
MED Fast Start Count : 3
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
MED Trap-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12;
Step Task Command(s)
1. Configure global system LLDP parameters
set lldp tx-interval
set lldp hold-multiplier
set lldp trap-interval
set lldp med-fast-repeat
clear lldp
2. Enable/disable specific ports to:
• Transmit and process received LLDPDUs
• Send LLDP traps
• Send LLDP-MED traps
set/clear lldp port status
set/clear lldp port trap
set/clear lldp port med-trap
3. Configure an ECS ELIN value for specific ports
set/clear lldp port location-info
4. Configure Network Policy TLVs for specific ports
set/clear lldp port network-policy
5. Configure which optional TLVs should be sent by
specific ports. For example, if you configured an
ECS ELIN and/or Network Policy TLVs, you must
enable those optional TLVs to be transmitted on
the specific ports.
set/clear lldp tx-tlv