Enterasys SECURESTACK C3, Configuration Manual, Page: 161 / 872

set lldp port tx-tlv
SecureStack C3 Configuration Guide 6-29
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example configures the management address, MED capability, MED network policy, and
MED location identification TLVs to be sent in LLDPDUs by port
ge.
1.1.
C3(rw)->set lldp port tx-tlv mgmt-addr med-cap med-pol med-loc ge.1.1
gvrp GVRP information defined by Protocol Identity IEEE 802.1
Extensions TLV. If LACP is enabled on the port, value sent includes
version of protocol being used.
mac ‐ phy MAC ‐ PHY Configuration/Status IEEE 802.3 Extensions TLV. Value
sent includes the operational MAU type, duplex, and speed of the
port.
poe Power via MDI IEEE 802.3 Extensions TLV. Values sent include
whether pair selection can be controlled on port, and the power class
supplied by the port. Only valid for PoE ‐ enabled ports.
link ‐ aggr Link Aggregation IEEE 802.3 Extensions TLV. Values sent indicate
whether the link associated with this port can be aggregated,
whether it is currently aggregated, and if aggregated, the aggregated
port identifier.
max ‐ frame Maximum Frame Size IEEE 802.3 Extensions TLV. Value sent
indicates maximum frame size of the port’s MAC and PHY.
med ‐ cap LLDP ‐ MED Capabilities TLV.Value sent indicates the capabilities
(whether the device supports location information, network policy,
extended power via MDI) and Device Type (network connectivity
device) of the sending device.
med ‐ pol LLDP ‐ MED Network Policy TLV. Values sent include application
name, VLAN type (tagged or untagged), VLAN ID, and both Layer 2
and Layer 3 priorities associated with application, for all applications
enabled on the port. See the set lldp port network ‐ policy command
for more information.
med ‐ loc LLDP ‐ MED Location Identification TLV. Value sent is the ECS ELIN
value configured on the port. See the set lldp port location ‐ info
command for more information.
med ‐ poe LLDP ‐ MED Extended Power via MDI TLV. Values sent include the
Power Limit (total power the port is capable of sourcing over a
maximum length cable) and the power priority configured on the
port. Only valid for PoE ‐ enabled ports.
port ‐ string Specifies the port or range of ports to be affected.