Enterasys SECURESTACK C3, Configuration Manual, Page: 59 / 872

set switch
SecureStack C3 Configuration Guide 2-9
Parameters
Defaults
None.
Mode
Switch command, read ‐ only.
Example
This example shows how to display data and error information on stack ports:
C3(ro)->show switch stack-ports
------------TX-------------- ------------RX-----------
Data Error Data Error
Stacking Rate Rate Total Rate Rate Total
Switch Port (Mb/s) (Errors/s) Errors (Mb/s) (Errors/s) Errors
------ ---------- ------ ---------- ---------- ------ ---------- --------
1 Up 0 0 0 0 0 0
Down 0 0 0 0 0 0
set switch
Use this command to assign a switch ID, to set a switch’s priority for becoming the management
switch if the previous management switch fails, or to change the switch unit ID for a switch in the
stack.
Syntax
set switch { unit [ priority value | renumber newunit ]}
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
unit (Optional) Specifies the switch unit ID, an integer ranging from 1 to 8.
unit Specifies a unit number for the switch. Value can range from 1 to 8.
priority value Specifies a priority value for the unit. Valid values are 1 to 15 with higher
values assigning higher priority.
renumber newunit Specifies a new number for the unit.
Note: This number must be a previously unassigned unit ID number.