Enterasys SECURESTACK C3, Configuration Manual, Page: 169 / 872

SecureStack C3 Configuration Guide 7-1
7
Port Configuration
This chapter describes the Port Configuration set of commands and how to use them.
Port Configuration Summary
Port String Syntax Used in the CLI
Commands requiring a port ‐ string parameter use the following syntax to designate port type, slot
location, and port number:
port type.unit_or_slot number.port number
Where port type can be:
fe for 100 ‐ Mbps Ethernet
ge for 1 ‐ Gbps Ethernet
tg for 10 ‐ Gbps Ethernet
host for the host port
vlan for vlan interfaces
lag for IEEE802.3 link aggregation ports
Where unit_or_slotnumber can be:
1 ‐ 8 for switch units in a stack
For information about... Refer to page...
Port Configuration Summary 7-1
Reviewing Port Status 7-2
Disabling / Enabling and Naming Ports 7-7
Setting Speed and Duplex Mode 7-11
Enabling / Disabling Jumbo Frame Support 7-14
Setting Auto-Negotiation and Advertised Ability 7-16
Setting Flow Control 7-22
Setting Port Link Traps and Link Flap Detection 7-24
Configuring Broadcast Suppression 7-33
Port Mirroring 7-36
Link Aggregation Control Protocol (LACP) 7-42
Configuring Protected Ports 7-56