Enterasys SECURESTACK C3, Configuration Manual, Page: 156 / 872

set lldp hold-multiplier
6-24 Discovery Protocol Configuration
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example sets the transmit interval to 20 seconds.
C3(rw)->set lldp tx-interval 20
set lldp hold-multiplier
Use this command to set the time ‐ to ‐ live value used in LLDP frames sent by this device. The time ‐
to ‐ live for LLDPDU data is calculated by multiplying the transmit interval by the hold multiplier
value.
Syntax
set lldp hold-multiplier multiplier-val
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example sets the transmit interval to 20 seconds and the hold multiplier to 5, which will
configure a time ‐ to ‐ live of 100 to be used in the TTL field in the LLDPDU header.
C3(rw)->set lldp tx-interval 20
C3(rw)->set lldp hold-multiplier 5
set lldp trap-interval
Use this command to set the minimum interval between LLDP notifications sent by this device.
LLDP notifications are sent when a remote system change has been detected.
Syntax
s et lldp trap-interval frequency
multiplier ‐ val Specifies the multiplier to apply to the transmit interval to determine
the time ‐ to ‐ live value. Value can range from 2 to 10. Default value is 4.