Enterasys SECURESTACK C3, Configuration Manual

Page: 148 / 872

show lldp port status
6-16 Discovery Protocol Configuration
show lldp port status
Use this command to display the LLDP status of one or more ports. The command lists the ports
that are enabled to send and receive LLDP PDUs. Ports are enabled or disabled with the set lldp
port status command.
Syntax
show lldp port status [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, LLDP status information will be displayed for all ports.
Mode
Switch command, read ‐ only.
Example
This example shows how to display LLDP port status information for all ports.
C3(ro)->show lldp port status
Tx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
Rx-Enabled Ports : ge.1.1-60; ge.2.1-24; ge.3.1-30; ge.4.1-12
show lldp port trap
Use this command to display the ports that are enabled to send an LLDP notification when a
remote system change has been detected or an LLDP ‐ MED notification when a change in the
topology has been sensed. Ports are enabled to send LLDP notifications with the set lldp port trap
command and to send LLDP ‐ MED notifications with the set lldp port med ‐ trap command.
Syntax
show lldp port trap [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, LLDP port trap information will be displayed for all ports.
Mode
Switch command, read ‐ only.
port ‐ string (Optional) Displays LLDP status for one or a range of ports.
port ‐ string (Optional) Displays the port or range of ports that have been enabled
to send LLDP and/or LLDP ‐ MED notifications.