Enterasys SECURESTACK C3, Configuration Manual, Page: 445 / 872

set sntp client
SecureStack C3 Configuration Guide 14-31
set sntp client
Use this command to set the SNTP operation mode.
Syntax
set sntp client { broadcast | unicast | disable }
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to enable SNTP in broadcast mode:
C3(su)->set sntp client broadcast
clear sntp client
Use this command to clear the SNTP client’s operational mode.
Syntax
clear sntp client
Parameters
None.
Last SNTP Update Date and time of most recent SNTP update.
Last SNTP Request Date and time of most recent SNTP request.
Last SNTP Status Whether or not broadcast reception or unicast transmission and reception was
successful.
SNTP-Server IP address(es) of SNTP server(s).
Precedence Precedence level of SNTP server in relation to its peers. Highest precedence is 1
and lowest is 10. Default of 1 can be reset using the
set sntp server command (“ set
sntp server ” on page 14-32).
Status Whether or not the SNTP server is active.
Table 14-7 show sntp Output Details (Continued)
Output Field What It Displays...
broadcast Enables SNTP in broadcast client mode.
unicast Enables SNTP in unicast (point ‐ to ‐ point) client mode. In this mode, the
client must supply the IP address from which to retrieve the current time.
disable Disables SNTP.