Enterasys SECURESTACK C3, Configuration Manual, Page: 713 / 872

area range
SecureStack C3 Configuration Guide 25-15
Parameters
Defaults
The default interval is 40 seconds.
Mode
Router OSPFv3 configuration: C3
(su)->router(Config-router)#
Usage
The stability interval is the period of time that an elected translator continues to perform its duties
after it determines that its translator status has been deposed by another router.
Example
This example sets the translator stability interval to 60 seconds for NSSA 20.
C3(su)->router(Config-router)# area 20 nssa translator-stab-intv 60
area range
This command creates an address range for the specified NSSA.
Syntax
area areaid range ipv6-prefix / prefix-length { summarylink | nssaexternallink }
[ advertise | not-advertise ]
no area areaid range ipv6-prefix / prefix-length
Parameters
Defaults
Area address ranges are not configured by default.
areaid Specifies the area ID in IP address format (dotted ‐ quad) or as a decimal
value.
interval Specifies the stability interval in seconds. The value of interval can range
from 0 to 3600 seconds.
areaid Specifies the area ID in IP address format (dotted ‐ quad) or as a decimal
value.
ipv6 ‐ prefix/prefix ‐ length Specifies IPv6 prefix and the length of the IPv6 prefix for the address
range. The prefix must be specified in hexadecimal using 16 ‐ bit values
between colons.
The value of prefix ‐ length is a decimal number indicating the number of
high ‐ order contiguous bits that comprise the prefix.
summarylink Specifies that route summarization should be based on summary LSAs.
nssaexternallink Specifies that route summarization should be based on external LSAs
Type 7.
advertise |
not ‐ advertise
(Optional) Specifies whether or not the routes should be advertised. If
neither parameter is specifies, the default is advertise .