Enterasys SECURESTACK C3, Configuration Manual

Page: 329 / 872

Creating and Naming Static VLANs
SecureStack C3 Configuration Guide 10-5
Creating and Naming Static VLANs
Purpose
To create a new static VLAN, or to enable or disable existing VLAN(s).
Commands
set vlan
Use this command to create a new static IEEE 802.1Q VLAN, or to enable or disable an existing
VLAN.
Syntax
set vlan {create | enable | disable} vlan-list
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Usage
Once a VLAN is created, you can assign it a name using the set vlan name command described in
“ set vlan name ” on page 10 ‐ 6.
Each VLAN ID must be unique. If a duplicate VLAN ID is entered, the device assumes that the
Administrator intends to modify the existing VLAN.
Enter the VLAN ID using a unique number between 1 and 4093. The VLAN IDs of 0 and 4094 and
higher may not be used for user ‐ defined VLANs.
Examples
This example shows how to create VLAN 3:
C3(su)->set vlan create 3
For information about... Refer to page...
set vlan 10-5
set vlan name 10-6
clear vlan 10-6
clear vlan name 10-7
create | enable |
disable
Creates, enables or disables VLAN(s).
vlan ‐ list Specifies one or more VLAN IDs to be created, enabled or disabled.