Enterasys SECURESTACK C3, Configuration Manual, Page: 767 / 872

show eapol
SecureStack C3 Configuration Guide 26-21
This example shows how to reset the 802.1X quiet period to 60 seconds on ports ge.1.1 ‐ 3:
C3(su)->clear dot1x auth-config quietperiod ge.1.1-3
show eapol
Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read ‐ only.
Example
This example shows how to display EAPOL status for ports
ge
.1.1 ‐ 3:
C3(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
ge.1.1 Initialize Auto
ge.1.2 Initialize Auto
ge.1.3 Initialize Auto
Table 26 ‐ 2 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to “ set eapol ” on
page 26 ‐ 23.
port ‐ string (Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port ‐ string values, refer to “ Port String Syntax Used
in the CLI ” on page 7 ‐ 1.