Enterasys SECURESTACK C3, Configuration Manual

Page: 180 / 872

set port speed
7-12 Port Configuration
set port speed
Use this command to set the default speed of one or more ports. This setting only takes effect on
ports that have auto ‐ negotiation disabled.
Syntax
set port speed port-string { 10 | 100 | 1000 }
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to set ge.3.3 to a port speed of 10 Mbps:
C3(su)->set port speed
ge.
3.3 10
show port duplex
Use this command to display the default duplex setting (half or full) for one or more ports.
Syntax
show port duplex [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, default duplex settings for all ports will be displayed.
Mode
Switch command, read ‐ only.
port ‐ string Specifies the port(s) for which to a speed value will be set. For a
detailed description of possible port ‐ string values, refer to “ Port
String Syntax Used in the CLI ” on page 7 ‐ 1.
10 | 100 | 1000 Specifies the port speed. Valid values are: 10 Mbps, 100 Mbps, or
1000 Mbps.
port ‐ string (Optional) Displays default duplex setting(s) for specific port(s).
For a detailed description of possible port ‐ string values, refer to
“ Port String Syntax Used in the CLI ” on page 7 ‐ 1.