Enterasys SECURESTACK C3, Configuration Manual

Page: 260 / 872

set snmp notify
8-32 SNMP Configuration
Example
This example shows how to display the SNMP notify information:
C3(su)->show snmp notify
--- SNMP notifyTable information ---
Notify name = 1
Notify Tag = Console
Notify Type = trap
Storage type = nonVolatile
Row status = active
Notify name = 2
Notify Tag = TrapSink
Notify Type = trap
Storage type = nonVolatile
Row status = active
Table 8 ‐ 10 provides an explanation of the command output.
set snmp notify
Use this command to set the SNMP notify configuration. This creates an entry in the SNMP notify
table, which is used to select management targets who should receive notification messages. This
command’s tag parameter can be used to bind each entry to a target address using the set snmp
targetaddr command (“ set snmp targetaddr ” on page 8 ‐ 27).
Syntax
set snmp notify notify tag tag [ trap | inform ] [ volatile | nonvolatile ]
Parameters
Defaults
If not specified, message type will be set to trap .
Table 8-10 show snmp notify Output Details
Output Field What It Displays...
Notify name A unique identifier used to index the SNMP notify table.
Notify Tag Name of the entry in the SNMP notify table.
Notify Type Type of notification: SNMPv1 or v2 trap or SNMPv3 InformRequest
message.
Storage type Whether access entry is stored in volatile , nonvolatile , or read-only
memory.
Row status Status of this entry: active , notInService , or notReady .
notify Specifies an SNMP notify name.
tag tag Specifies an SNMP notify tag. This binds the notify name to the SNMP
target address table.
trap | inform (Optional) Specifies SNMPv1 or v2 Trap messages (default) or SNMP v3
InformRequest messages.
volatile |
nonvolatile
(Optional) Specifies temporary (default), or permanent storage for SNMP
entries.