Enterasys SECURESTACK C3, Configuration Manual, Page: 46 / 872

Using the Command Line Interface
1-6 Introduction
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
Connect a terminal to the local console port as described in your SecureStack C3 Installation Guide .
The startup screen, Figure 1 ‐ 1 , will display on the terminal. You can now start the Command Line
Interface (CLI) by
• using a default user account, as described in “ Using a Default User Account ” on page 1 ‐ 7, or
• using an administratively ‐ assigned user account as described in “ Using an Administratively
Configured User Account ” on page 1 ‐ 7.
Figure 1-1 SecureStack C3 Startup Screen
Split horizon Enabled for RIP packets without poison reverse.
Stub area (OSPF) None configured.
Telnet Enabled.
Telnet port (IP) Set to port number 23.
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
Table 1-2 Default Settings for Router Operation (Continued)
Output... What it displays...
Username:admin
Password:
Enterasys SecureStack C3
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2008
Chassis Serial Number: 041800249041
Chassis Firmware Revision: 6.03.xx.xxxx
C3(su)->