Enterasys SECURESTACK C3, Configuration Manual, Page: 544 / 872

Enabling Router Configuration Modes
18-2 Preparing for Router Mode
Example
The following example shows how to configure VLAN 1 on IP address 182.127.63.1 255.255.255.0
as a routing interface.
C3(su)->router
C3(su)->router>enable
C3(su)->router#configure
Enter configuration commands:
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip address 182.127.63.1 255.255.255.0
C3(su)->router(Config-if(Vlan 1))#no shutdown
Enabling Router Configuration Modes
The SecureStack C3 CLI provides different modes of router operation for issuing a subset of
commands from each mode. Table 18 ‐ 2 describes these modes of operation.
Table 18-1 Enabling the Switch for Routing
Step To do this task... Type this command... At this prompt... For details, see...
1 From admin (su) mode,
enable router mode. router Switch:
C3(su)->
2 Enable router Privileged
EXEC mode. enable Router:
C3(su)->router>
3 Enable global router
configuration mode. configure Router:
C3(su)->router#
4 Enable interface
configuration mode using the
routing VLAN or loopback id. interface { vlan vlan-id | loopback
loop-id }
Router:
C3(su)>router(Config)#
“ interface ” on page
19-3
5 Assign an IP address to the
routing interface. ip address { ip-address ip-mask } Router:
C3(su)->router (Config-if
(Vlan 1))#
“ interface ” on page
19-3
6 Enable the interface for IP
routing. no shutdown Router:
C3(su)->router(Config-if
(Vlan 1))#
“ no shutdown ” on
page 19-6
Table 18-2 Router CLI Configuration Modes
Use this mode... To... Access method... Resulting Prompt...
Privileged EXEC
Mode Set system operating
parameters
Show configuration
parameters
Save/copy
configurations
From the switch CLI:
Type router , then
Type enable .
C3(su)->router>
C3(su)->router#
Global Configuration
Mode Set system-wide
parameters. Type configure from
Privileged EXEC mode.
C3(su)->router (Config)#
Interface
Configuration Mode Configure router
interfaces. Type interface vlan or
loopback and the
interface’s id from Global
Configuration mode.
C3(su)->router(Config-if
(Vlan 1))#
C3(su)->router(Config-if
(Lpbk 1))#