Dell Force10 E300, Configuration Manual

Page: 936 / 1262

936 | Security
www.dell.com | support.dell.com
FTOS supports both inbound and outbound SSH sessions using IPv4 or IPv6 addressing. Inbound SSH
supports accessing the system through the management interface as well as through a physical Layer 3
interface.
For details on command syntax, see the Security chapter in the FTOS Command Line Interface Reference .
SCP is a remote file copy program that works with SSH and is supported by FTOS.
To use the SSH client, use the following command in the EXEC Privilege mode:
To enable the SSH server for version 1 and 2, use the following command in the CONFIGURATION
mode:
To enable the SSH server for version 1 or 2 only, use the following command:
To view the SSH configuration, use the following command in EXEC Privilege mode:
Figure 45-6 on page 937 shows the use of the command
ip ssh server version 2
to enable SSH version 2,
and the
show ip ssh
command to confirm the setting.
Note: The Windows-based WinSCP client software is not supported for secure copying between a PC
and an FTOS-based system. Unix-based SCP client software is supported.
Command Syntax Command Mode Purpose
ssh
{
hostname | hostip
} [
-l
username |
-p
port-number |
-v
{
1
|
2
}
EXEC Privilege Open an SSH connection specifying the hostname or
hostip
, username, port number, and version of the SSH
client.
hostip
is the IP address of the remote device, which can
be an IPv4 address (A.B.C.D)or IPv6 address
(X:X:X:X::X).
Command Syntax Command Mode Purpose
ip ssh server
{
enable | port
port-number } CONFIGURATION Configure the Dell Force10 system as an
SCP/SSH server.
Command Syntax Command Mode Purpose
ip ssh server version
{
1|2
} CONFIGURATION Configure the Dell Force10 system as an SSH server that
uses only version 1 or 2.
Command Syntax Command Mode Purpose
show ip ssh
EXEC Privilege Display SSH connection information.