Dell Force10 E300, Configuration Manual, Page: 465 / 1262

IPv4 Addressing | 465
To assign an IP address to an interface, use these commands in the following sequence, starting in the
CONFIGURATION mode:
To view the configuration, use the
show config
command (Figure 246) in the INTERFACE mode or
show
ip interface
in the EXEC privilege mode (Figure 247) .
Figure 21-1. show config Command Example in the INTERFACE Mode
Figure 21-2. show ip interface Command Example
Step Command Syntax Command Mode Purpose
1
interface
interface
CONFIGURATION Enter the keyword
interface
followed by the type of
interface and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback
followed by a number from 0 to 16383.
• For the Management interface on the RPM, enter the
keyword
ManagementEthernet
followed by the slot/
port information. The slot range is 0-1 and the port range
is 0.
• For a port channel interface, enter the keyword
port-channel
followed by a number from 1 to 255 for
TeraScale and ExaScale, 1 to 32 for EtherScale.
• For a SONET interface, enter the keyword
sonet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port
information.
• For a VLAN interface, enter the keyword
vlan
followed
by a number from 1 to 4094.
E-Series ExaScale platforms support 4094 VLANs
with FTOS version 8.2.1.0 and later. Earlier
ExaScale supports 2094 VLANS.
2
no shutdown
INTERFACE Enable the interface.
3
ip address
ip-address
mask
[
secondary
]
INTERFACE Configure a primary IP address and mask on the interface.
•
ip-address mask:
IP address must be in dotted decimal
format (A.B.C.D) and the mask must be in slash
prefix-length format (/24).
Add the keyword
secondary
if the IP address is the
interface’s backup IP address. You can configure up to eight
secondary IP addresses.
FTOS(conf-if)#show conf
!
interface GigabitEthernet 0/0
ip address 10.11.1.1/24
no shutdown
!
FTOS(conf-if)#