Dell Force10 E300, Configuration Manual, Page: 141 / 1262

IP Access Control Lists (ACL), Prefix Lists, and Route-maps | 141
A standard IP ACL uses the source IP address as its match criterion.
To configure a standard IP ACL, use these commands in the following sequence:
When you use the
log
keyword, CP processor logs details about the packets that match. Depending on how
many packets match the log entry and at what rate, the CP may become busy as it has to log these packets’
details.
To view the rules of a particular ACL configured on a particular interface, use the
show ip accounting
access-list
ACL-name
interface
interface
command (Figure 226) in EXEC Privilege mode.
Figure 8-3. Command Example:
show ip accounting access-list
Figure 8-4 illustrates how the
seq
command orders the filters according to the sequence number assigned.
In the example, filter 25 was configured before filter 15, but the
show config
command displays the filters
in the correct order.
Note: On E-Series ExaScale systems, TCP ACL flags are not supported in standard or extended ACLs
with IPv6 microcode. An error message is shown if IPv6 microcode is configured and an ACL is entered
with a TCP filter included.
FTOS(conf-ipv6-acl)#seq 8 permit tcp any any urg
May 5 08:32:34: %E90MJ:0 %ACL_AGENT-2-ACL_AGENT_ENTRY_ERROR: Unable to write seq 8 of
list test as individual TCP flags are not supported on linecard 0
Step Command Syntax Command Mode Purpose
1
ip access-list standard
access-listname CONFIGURATION Enter IP ACCESS LIST mode by
naming a standard IP access list.
2
seq
sequence-number {
deny
|
permit
}
{ source [ mask ] |
any | host
ip-address }
[
count
[
byte
] |
log
] [
order
] [
monitor
]
[
fragments
]
CONFIG-STD-NACL Configure a drop or forward filter. The
parameters are:
•
log
and
monitor
options are
supported on E-Series only.
Note: When assigning sequence numbers to filters, keep in mind that you might need to insert a
new filter. To prevent reconfiguring multiple filters, assign sequence numbers in multiples of five or
another number.
FTOS# show ip accounting access ToOspf interface gig 1/6
Standard IP access list ToOspf
seq 5 deny any
seq 10 deny 10.2.0.0 /16
seq 15 deny 10.3.0.0 /16
seq 20 deny 10.4.0.0 /16
seq 25 deny 10.5.0.0 /16
seq 30 deny 10.6.0.0 /16
seq 35 deny 10.7.0.0 /16
seq 40 deny 10.8.0.0 /16
seq 45 deny 10.9.0.0 /16
seq 50 deny 10.10.0.0 /16
FTOS#