Dell Force10 E300, Configuration Manual, Page: 88 / 1262

88 | 802.1ag
www.dell.com | support.dell.com
Enable CCM
Enable Cross-checking
Loopback Message and Response
Loopback Message and Response (LBM, LBR), also called Layer 2 Ping, is an administrative echo
transmitted by MEPs to verify reachability to another MEP or MIP within the maintenance domain. LBM
and LBR are unicast frames.
Linktrace Message and Response
Linktrace Message and Response (LTM, LTR), also called Layer 2 Traceroute, is an administratively sent
multicast frames transmitted by MEPs to track, hop-by-hop, the path to another MEP or MIP within the
maintenance domain. All MEPs and MIPs in the same domain respond to an LTM with a unicast LTR.
Intermediate MIPs forward the LTM toward the target MEP.
Step Task Command Syntax Command Mode
1 Enable CCM.
no ccm disable
Default: Disabled
ECFM DOMAIN
2 Configure the transmit interval (mandatory).
The interval specified applies to all MEPs in
the domain.
ccm transmit-interval
seconds
Default: 10 seconds
ECFM DOMAIN
Task Command Syntax Command Mode
Enable cross-checking.
mep cross-check enable
Default: Disabled
ETHERNET CFM
Start the cross-check operation for an MEP.
mep cross-check
mep-id
ETHERNET CFM
Configure the amount of time the system waits for a
remote MEP to come up before the cross-check operation
is started.
mep cross-check start-delay
number
ETHERNET CFM
Task Command Syntax Command Mode
Send a Loopback message.
ping ethernet domain
name
ma-name
ma-name
remote
{
mep-id
|
mac-addr
mac-address
}
source
{
mep-id
|
port
interface
}
EXEC Privilege