Dell Force10 E300, Configuration Manual, Page: 469 / 1262

IPv4 Addressing | 469
To view current bindings, use the
show hosts
command.
Figure 21-5. show hosts Command Example
To view the current configuration, use the
show running-config resolve
command.
Specify local system domain and a list of domains
If you enter a partial domain, FTOS can search different domains to finish or fully qualify that partial
domain. A fully qualified domain name (FQDN) is any name that is terminated with a period/dot. FTOS
searches the host table first to resolve the partial domain. The host table contains both statically configured
and dynamically learnt host and IP addresses. If FTOS cannot resolve the domain, it tries the domain name
assigned to the local system. If that does not resolve the partial domain, FTOS searches the list of domains
configured
To configure a domain name, use the following command in the CONFIGURATION mode:
To configure a list of domain names, use the following command in the CONFIGURATION mode:
Command Syntax Command Mode Purpose
ip domain-lookup
CONFIGURATION Enable dynamic resolution of host names.
ip name-server
ipv4-address
[
ipv4-address2
...
ipv4-address6
]
ipv6 name-server
ipv6-address
[
ipv6-address2
...
ipv6-address6
]
CONFIGURATION Specify up to 6 IPv4 or IPv6 name servers. The order you
entered the servers determines the order of their use. You
may have IPv4 and IPv6 name servers configured at the
same time.
Command Syntax Command Mode Purpose
ip domain-name
name
CONFIGURATION Configure one domain name for the E-Series
FTOS>show host
Default domain is force10networks.com
Name/address lookup uses domain service
Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
patch1 (perm, OK) - IP 192.68.69.2
tomm-3 (perm, OK) - IP 192.68.99.2
gxr (perm, OK) - IP 192.71.18.2
f00-3 (perm, OK) - IP 192.71.23.1
FTOS>