Dell Force10 E300, Configuration Manual, Page: 263 / 1262

Border Gateway Protocol IPv4 (BGPv4) | 263
Change BGP timers
Use either or both of the following commands in the CONFIGURATION ROUTER BGP mode to
configure BGP timers.
Use the
show config
command in CONFIGURATION ROUTER BGP mode or the
show running-config
bgp
command in EXEC Privilege mode to view non-default values.
Timer values configured with the
neighbor timers
command override the timer values configured with the
timers bgp
command.
When two neighbors, configured with different
keepalive
and
holdtime
values, negotiate for new values, the
resulting values will be as follows:
• the lower of the
holdtime
values is the new
holdtime
value, and
• whichever is the lower value; one-third of the new
holdtime
value, or the configured
keepalive
value is
the new
keepalive
value.
BGP neighbor soft-reconfiguration
Changing routing policies typically requires a reset of BGP sessions (the TCP connection) for the policies
to take effect. This type of reset causes undue interruption to traffic due to the hard reset of the BGP cache
and the time it takes to re-establish the session.
BGP soft reconfiguration allows you to re-apply policies to a session without resetting the BGP session.
You can perform soft reconfiguration on a per-neighbor basis for either inbound or outbound policies. BGP
soft reconfiguration clears and reapplies policies without resetting the TCP connection.
Command Syntax Command Mode Purpose
neighbors
{
ip-address
|
peer-group-name
}
timers
keepalive
holdtime
CONFIG-ROUTER-
BGP Configure timer values for a BGP neighbor or peer
group.
•
keepalive
range: 1 to 65535. Time interval, in
seconds, between keepalive messages sent to the
neighbor routers. (Default: 60 seconds)
•
holdtime
range: 3 to 65536. Time interval, in
seconds, between the last keepalive message and
declaring the router dead. (Default: 180 seconds)
timers bgp
keepalive holdtime
CONFIG-ROUTER-
BGP Configure timer values for all neighbors.
•
keepalive
range: 1 to 65535. Time interval, in
seconds, between keepalive messages sent to the
neighbor routers. (Default: 60 seconds)
•
holdtime
range: 3 to 65536. Time interval, in
seconds, between the last keepalive message and
declaring the router dead. (Default: 180 seconds)