Dell Force10 E300, Configuration Manual, Page: 160 / 1262

160 | IP Access Control Lists (ACL), Prefix Lists, and Route-maps
www.dell.com | support.dell.com
Figure 8-20. Resequencing Remarks
Route Maps
Route-maps are supported on platforms:
c e s
Like ACLs and prefix lists, route maps are composed of a series of commands that contain a matching
criterion and an action, yet route maps can change the packets meeting the criterion. ACLs and prefix lists
can only drop or forward the packet or traffic. Route maps process routes for route redistribution. For
example, a route map can be called to filter only specific routes and to add a metric.
Route maps also have an “implicit deny.” Unlike ACLs and prefix lists, however, where the packet or
traffic is dropped, in route maps, if a route does not match any of the route map conditions, the route is not
redistributed.
Implementation Information
The FTOS implementation of route maps allows route maps with no match command or no set command.
When there is no match command, all traffic matches the route map and the set command applies.
FTOS(config-ext-nacl)# show config
!
ip access-list extended test
remark 4 XYZ
remark 5 this remark corresponds to permit any host 1.1.1.1
seq 5 permit ip any host 1.1.1.1
remark 9 ABC
remark 10 this remark corresponds to permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.2
seq 15 permit ip any host 1.1.1.3
seq 20 permit ip any host 1.1.1.4
FTOS# end
FTOS# resequence access-list ipv4 test 2 2
FTOS# show running-config acl
!
ip access-list extended test
remark 2 XYZ
remark 4 this remark corresponds to permit any host 1.1.1.1
seq 4 permit ip any host 1.1.1.1
remark 6 this remark has no corresponding rule
remark 8 this remark corresponds to permit ip any host 1.1.1.2
seq 8 permit ip any host 1.1.1.2
seq 10 permit ip any host 1.1.1.3
seq 12 permit ip any host 1.1.1.4