Dell Force10 E300, Configuration Manual

Page: 886 / 1262

886 | Routing Information Protocol
www.dell.com | support.dell.com
To enable RIP debugging, use the following command in the EXEC privilege mode:
Figure 42-6 shows the confirmation when the debug function is enabled.
Figure 42-6. debug ip rip Command Example
To disable RIP, use the
no debug ip rip
command.
RIP Configuration Example
The example in this section shows the command sequence to configure RIPv2 on the two routers shown in
Figure 42-7 — “Core 2” and “Core 3”. The host prompts used in the example screenshots reflect those
names. The screenshots are divided into the following groups of command sequences:
• Configuring RIPv2 on Core 2 on page 887
• Core 2 Output on page 887
• RIP Configuration on Core 3 on page 889
• Core 3 RIP Output on page 889
• RIP Configuration Summary on page 891
Figure 42-7. RIP Topology Example
Command Syntax Command Mode Purpose
debug ip rip
[ interface |
database
|
events
|
trigger
] EXEC privilege Enable debugging of RIP.
FTOS#debug ip rip
RIP protocol debug is ON
FTOS#
GigE 3/11 GigE 3/11 10.11.30.1 /24
GigE 3/21
GigE 3/21 10.11.20.1 /24
GigE 2/11 GigE 2/11 10.11.10.1 /24
GigE 2/31
GigE 2/31 10.11.20.2 /24
Core 2 Core 3
GigE
2/31
GigE
3/21
GigE 3/43 GigE 3/43 192.168.1.0 /24
GigE 3/44
GigE 3/44 192.168.2.0 /24
GigE 2/41 GigE 2/41 10.200.10.0 /24
GigE 2/42
GigE 2/42 10.300.10.0 /24