Dell Force10 E300, Configuration Manual

Page: 47 / 1262

Getting Started | 47
Configure a Host Name
The host name appears in the prompt. The default host name is
force10
.
• Host names must start with a letter and end with a letter or digit.
• Characters within the string can be letters, digits, and hyphens.
To configure a host name:
Figure 3-2 illustrates the
hostname
command.
Figure 3-2. Configuring a Hostname
Access the System Remotely
You can configure the system to access it remotely by Telnet. The method for configuring the C-Series and
E-Series for Telnet access is different from S-Series.
• The C-Series and E-Series have a dedicated management port and a management routing table that is
separate from the IP routing table.
• The S-Series does not have a dedicated management port, but is managed from any port. It does not
have a separate management routing table.
Access the C-Series and E-Series Remotely
Configuring the system for Telnet is a three-step process:
1. Configure an IP address for the management port. See Configure the Management Port IP Address .
2. Configure a management route with a default gateway. See Configure a Management Route .
3. Configure a username and password. See Configure a Username and Password .
Step Task Command Syntax Command Mode
1 Create a new host name.
hostname
name
CONFIGURATION
Note: Use this process for the S60 system.
FTOS(conf)#hostname R1
R1(conf)#
Default Hostname
New Hostname