Dell Force10 E300, Configuration Manual, Page: 316 / 1262

316 | Dynamic Host Configuration Protocol
www.dell.com | support.dell.com
To create an address pool:
Once an IP address is leased to a client, only that client may release the address. FTOS performs a IP +
MAC source address validation to ensure that no client can release another clients address. This is a default
behavior, and is separate from
IP+MAC Source Address Validation on page 328 .
Exclude Addresses from the Address Pool
The DHCP server assumes that all IP addresses in a DHCP address pool are available for assigning to
DHCP clients. You must specify the IP address that the DHCP server should not assign to clients.
Specify an Address Lease Time
Specify a Default Gateway
The IP address of the default router should be on the same subnet as the client.
Step Task Command Syntax Command Mode
1 Access the DHCP server CLI context.
ip dhcp server
CONFIGURATION
2 Create an address pool and give it a name.
pool
name
DHCP
3 Specify the range of IP addresses from which the
DHCP server may assign addresses.
• network is the subnet address.
• prefix-length specifies the number of bits
used for the network portion of the address
you specify.
network
network
/
prefix-length
Prefix-length Range: 17-31
DHCP <POOL>
4 Display the current pool configuration.
show config
DHCP <POOL>
Task Command Syntax Command Mode
Exclude an address range from DHCP assignment. The
exclusion applies to all configured pools.
excluded-address
DHCP
Task Command Syntax Command Mode
Specify an address lease time for the addresses in
a pool.
lease
{
days
[
hours
] [
minutes
] |
infinite
}
Default: 24 hours
DHCP <POOL>
Task Command Syntax Command Mode
Specify default gateway(s) for the clients on the subnet, in
order of preference.
default-router
address DHCP <POOL>