Dell Force10 E300, Configuration Manual

Page: 579 / 1262

Layer 2 | 579
Entering the
show fefd
command in EXEC privilege mode displays information about the state of each
interface.
Figure 25-11. Show FEFD global outputs
Enable FEFD on an Interface
Entering the command
fefd
in INTERFACE mode enables FEFD on a per interface basis. To change the
FEFD mode, supplement the fefd command in INTERFACE mode by entering the command fefd [ mode
{
aggressive
|
normal
}].
To disable FEFD protocol on one interface, enter the command
fefd disable
in INTERFACE mode.
Disabling an interface will shut down all protocols working on that interface’s connected line, and will not
delete your previous FEFD configuration which can be enabled again at any time.
2
Activate the necessary ports
administratively
no shutdown
INTERFACE
3
Enable fefd globally
fefd
{
interval
|
mode
}
CONFIGURATION
Step Task Command Syntax Command Mode
1
Setup two or more connected
interfaces for Layer 2 or Layer 3 use
ip address
ip
address ,
switchport
INTERFACE
2
Activate the necessary ports
administratively
no shutdown
INTERFACE
3
Enable FEFD on each interface
fefd
{
disable |
interval
|
mode
}
INTERFACE
Step Task Command Syntax Command Mode
FTOS#show fefd
FEFD is globally 'ON', interval is 3 seconds, mode is 'Normal'.
INTERFACE MODE INTERVAL STATE
(second)
Gi 1/0 Normal 3 Bi-directional
Gi 1/1 Normal 3 Admin Shutdown
Gi 1/2 Normal 3 Admin Shutdown
Gi 1/3 Normal 3 Admin Shutdown
FTOS#show run fefd
!
fefd-global mode normal
fefd-global interval 3