Dell Force10 E300, Configuration Manual, Page: 766 / 1262

766 | PIM Sparse-Mode
www.dell.com | support.dell.com
To prevent these delivery errors you must statically map the potential incoming interfaces for the (*,G)
entries via the CLI. When you create this mapping, (*,G) entries are programmed in hardware. Packets are
then fast forwarded starting with the first packet, and the potential for these delivery errors is avoided.
Monitoring PIM
The PIM MIB is supported only on platform
e
FTOS fully supports the PIM MIB as specified in RFC 5060 with some exceptions.
• The following tables are not supported:
• pimBidirDFElectionTable
• pimAnycastRPSetTable
• The OIDs related to InvalidRegisterMsgs reflect the last received invalid register message. Similarly,
the OIDs related to InvalidJoinPruneMsgs reflect the last received invalid Join or Prune message.
• OIDs which refer to any timer show the time that the timer started; it is 0 otherwise.
PIM-SM and IGMP Snooping: Usage Notes
PIM-SM is supported with IGMP snooping. Figure 34-10 shows the egress ports used for outgoing
multicast traffic when you enable different combinations of PIM-SM DR flooding and IGMP snooping
flooding on a switch/router.
When you enable PIM-SM and IGMP snooping at the same time:
• The IGMP report is forwarded on the port that connects to the PIM DR.
• The port that connects to the PIM DR port and ports on which IGMP queries are received are chosen as
IGMP router ports. It is recommended that you configure the both the IGMP querier and the PIM DR
in the same router to avoid unnecessary flooding.
Step Task Command Syntax Command Mode
1
Create a standard access-list that
permits one or more IGMP groups.
ip access-list standard
name
CONFIGURATION
FTOS(config-std-nacl)#show config
!
ip access-list standard map1
seq 5 permit 224.0.0.0/24
2 Apply the ACL to an interface on
which there might be a source for a
group specified in the ACL. This
command maps the incoming
interface to the (*,G) entry so that the
entry can be programmed into
hardware.
ip pim ingress-interface-map
std-access-lis t INTERFACE