CF MOTO CF500-5, Service Manual

Page: 184 / 254

8 FRONT WHEEL,BRAKE SUSPENSION,STEERING SYSTEM
8 8 8 8 8
8-7
Assembling
Assembling carry on according to the oppsite se-
quence of disassembling.
Attention:Oil tube trend refers to section 1 cable,
wire line traces, brake oil line must be smooth.
Brake force checking is needed after finish the
brake system installation, if it cannot join control,
check the cross plug.
Front suspension system
Front left suspension as-
semble
Attention: when repairing suspension, you must not
remove both LH and RH suspension at one time, or
else the body will fall down because lack of holding
power.
Disassemble
Put vehicle body into horizontal position, use jack hold
the wheel front firmly.
remove front wheel(8-3)
remove front rim hub(8-3)
remove caliper(8-4)
remove front left absorber bolt 1 and tightening nut 1
installed on the body.
remove front left upper arm bolt 1 and tightening bolt
1,nut 1; bolt 2 and bolt 2, nut 2 installed in the frame.
remove front left lower arm bolt 3 and tightening nut 3,
bolt 4 and tightening nut4 installed in the frame.
remove steering tie-rod ball pin slot nut, remove the
steering pie-rod
pull up joint knuckle from the driveshaft, remove front
left suspension assy.